Set the management port speed and the duplex mode

Set the speed of the Management port and determine whether the port should be set to half-duplex or full-duplex. At the prompt, type:

set mgmtport speed <10 | 100 | 1000 | 10000> duplex <half | full>

where< 10> indicates 10 Mbps, < 100> indicates 100 Mbps, < 1000> indicates 1000 Mbps, < 10000> indicates 10000 Mbps, < half> indicates half-duplex, and < full > indicates full-duplex.

Example: set mgmtport speed 100 duplex half

Note

Management port speed settings vary depending on the Sensor model used. Availability of half duplex option depends on the management port speed you set.

Note

This command is not applicable for NS9600, NS9500, NS7600, NS7500, and NS3600 Sensors. Duplex option is not available in 9100, 9200, and 9300 Sensors.