--- title: "Set the port throughput usage threshold for specific devices" slug: "set-the-port-throughput-usage-threshold-for-specific-devices-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:31Z published: 2026-11-19T12:29:31Z canonical: "docs.trellix.com/set-the-port-throughput-usage-threshold-for-specific-devices-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Set the port throughput usage threshold for specific devices Port throughput usage is configurable for specific devices within a given network domain. The Port Throughput tab appears when the sensor supports port throughput monitoring and applies to device level configuration, not an admin domain level. Under usage, in the context of the Throughput Usage threshold, is a 'falling threshold'. An alarm is generated when the Throughput % drops below a certain value. This is helpful on busy networks, where a certain amount of traffic is always expected to be seen. This type of alarm is a good indication that there is a communication problem on the network. > [!NOTE] > Note > > On sensors with many monitoring ports, this option can produce a large quantity of data. It is disabled by default to optimize Manager disk space. Follow this procedure for setting the port throughput usage threshold for each device within a domain. 1. From the Performance Monitoring node, select **Devices > ** > Devices > ** > Setup > Performance Monitoring > Thresholds**. 2. Select the **Port Throughput** tab. ![](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/IPS-manager-performance-monitoring-thresholds-port-throughput.png?sv=2026-02-06&spr=https&st=2026-11-20T13%3A19%3A02Z&se=2026-11-20T14%3A19%3A02Z&sr=c&sp=r&sig=bm96ZVxcLFT9hSEf5Ag3uer%2BfGkLQuUR4poZ0nsouRw%3D) Performance Monitor - Thresholds tab: Port Throughput 3. Select a row and enter the required threshold percentage in the **Threshold** field. This value should be higher than the value in the **Reset Threshold** field. 4. In the **Ports** area, select a port to assign specific thresholds to it. 5. (Optional) Select the **Generate Fault** checkbox 6. Click **Save**. > [!NOTE] > Note > > Select **Reset** to revert the port assignments updates.