--- title: "Setting the Sensor throughput threshold for specific devices" slug: "setting-the-sensor-throughput-threshold-for-specific-devices" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:41:06Z published: 2026-10-05T15:41:06Z canonical: "docs.trellix.com/setting-the-sensor-throughput-threshold-for-specific-devices" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Setting the Sensor throughput threshold for specific devices Follow this procedure for setting the Sensor throughput threshold for a specific device within a domain. ## Task 1. Select **Devices** → **** → **Devices** → **** → **Setup** → **Performance Monitoring** → **Thresholds**. Thresholds sub-tab ![](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/GUID-F01E307F-C1A0-4273-835A-C26269CECE9C-low.png?sv=2026-02-06&spr=https&st=2026-11-22T14%3A34%3A34Z&se=2026-11-22T15%3A34%3A34Z&sr=c&sp=r&sig=lAhZVlGN8xoDT2MOYn9HfdR4UwHQVKlY8Z9nuDSjNis%3D) 2. Select **Device Throughput Usage** in the drop down list against **Metric**. 3. Enter the required threshold percentage in the **Threshold [%]** column (this value should be higher than the value in the **Reset Threshold [%]** column). 4. Select **Generate Fault?** generate fault. 5. Click **Save**. > [!NOTE] > Note > > Click **Defaults** to set the threshold settings to the default values. **Under Usage** in the context of the throughput usage threshold is a 'falling threshold'. A fault is generated when the throughput % drops below a certain value. This is helpful on very busy networks, where a certain amount of traffic is always expected to be seen. This type of fault is a good indication that there is a communication problem on the network.