This command is used to setup Sensor parameters. You are required to run this command when you newly set up your Sensor or after resetting the Sensor by using the factorydefaults command.
This command has no parameters.
Syntax:
setup
When you enter this command, you are prompted to enter the following:
Current password
New password
System mode
Note
System mode is available only for the NS9600 and NS9500 Sensors.
Sensor name
IP Type (IPv4=1 or IPv6=2 or BOTH=3)
Sensor IP (IPv4 or IPv6 address or BOTH)
Sensor subnet mask (IP address)
Manager primary IP (IPv4 or IPv6 address or BOTH)
Manager secondary IP (IPv4 or IPv6 address or BOTH)
Sensor default gateway (IPv4 or IPv6 address or BOTH)
Management port configuration choice (a/m)
Shared secret key
Note
If you press the Enter button, your current settings are taken as default.
Applicable to:
NS-series Sensors