--- title: "setup" slug: "setup-6" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:31:15Z published: 2026-11-19T12:31:15Z canonical: "docs.trellix.com/setup-6" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # setup This command is used to setup Sensor parameters. You are required to run this command when you newly set up your Sensor or after resetting the Sensor by using the `factorydefaults` command. This command has no parameters. **Syntax**: `setup` When you enter this command, you are prompted to enter the following: - Current password - New password - System mode > [!NOTE] > Note > > System mode is available only for the NS9600 and NS9500 Sensors. - Sensor name - IP Type (IPv4=1 or IPv6=2 or BOTH=3) - Sensor IP (IPv4 or IPv6 address or BOTH) - Sensor subnet mask (IP address) - Manager primary IP (IPv4 or IPv6 address or BOTH) - Manager secondary IP (IPv4 or IPv6 address or BOTH) - Sensor default gateway (IPv4 or IPv6 address or BOTH) - Management port configuration choice (a/m) - Shared secret key > [!NOTE] > Note > > If you press the **Enter** button, your current settings are taken as default. **Applicable to:** NS-series Sensors