Upon execution, this command displays all the current configuration settings on the Sensor, such as the model, installed software version, IP address, and Manager details.
This command has no parameters.
Syntax:
show
Information displayed by the show command includes the following:
[Sensor Info]
- System Name
- Date
- System Uptime
- System Type
- System serial number (displays the primary, secondary and master/system serial numbers separately in case of NS9300)
- Software Version
- Hardware Version
- MGMT Ethernet Port
- MGMT port Link Status
[Sensor Network Config]
- IP Address
- Netmask
- Default Gateway
- SSH Remote Logins
[Manager Config]
Self Signed cert support
- Install TCP Port
- Alert TCP Port
- Logging TCP Port
CA Signed cert support
- Install TCP Port
- Alert TCP Port
- Logging TCP Port
- FIPS Mode
- Admin SSH/Console Access
Sample Output:
For Sensor, the output is as shown:
intruShell@john> show
[Sensor Info]
System Name : NS9300
Date : 7/12/2018 - 9:14:9 UTC
System Uptime : 03 hrs 15 min 35 secs
System Type : IPS-NS9300
Serial Number : J021834009
Software Version : 9.1.166.26
Hardware Version : 1.30
MGMT Ethernet port : auto negotiated
MGMT port Link Status : link up
[Sensor Network Config]
IP Address : 10.213.174.202
Netmask : 255.255.255.0
Default Gateway : 10.213.174.201
SSH Remote Logins : enabled
[Manager Config]
Self Signed cert support
Install TCP Port : 8501
Alert TCP Port : 8502
Logging TCP Port : 8503
CA Signed cert support
Install TCP Port : 8506
Alert TCP Port : 8507
Logging TCP Port : 8508
Applicable to:
NS-series Sensors