This command displays all the current configuration settings on the Sensor, such as model, installed software version, IP address, and Manager details.
This command has no parameters.
Syntax:
show
Information displayed by the show command includes the following:
[Sensor Info]
Date
System Uptime
System Type
System Mode
Note
System mode is displayed only for the NS9600 and NS9500 Sensors.
Serial Number (displays the primary, secondary and master/system serial numbers separately in case of NS9300)
Software Version
Hardware Version
MGMT Ethernet Port
MGMT port Link Status
[Sensor Network Config]
IP Address
Netmask
Default Gateway
Default SCPserver
IPv6 Address
Default IPv6 Gateway
Note
The IPv6 Address and Default IPv6 Gateway are displayed if the Sensor is configured for IPv6.
SSH Remote Logins
[Manager Config]
Manager IP addr (IPv4 or IPv6)
RSA Key Size
Install TCP Port
Alert TCP Port
Logging TCP Port
[Peer Manager Config]
Manager IP addr (IPv4 or IPv6)
RSA Key Size
Install TCP Port
Alert TCP Port
Logging TCP Port
Sample Output:
[Sensor Info] System Name : NS7600 Date : 11/17/2025 - 20:16:42 UTC System Uptime : 06 hrs 39 min 04 secs System Type : IPS-NS7600 System Mode : Standalone Serial Number : A000210001 Software Version : 11.1.2xx.1xx Hardware Version : 1.00 MGMT Ethernet port : auto negotiated MGMT port Link Status : link up [Sensor Network Config] IP Address : 10.1.1.1 Netmask : 255.255.255.0 Default Gateway : 10.1.1.2 Default SCPserver : 10.1.1.3 IPv6 Address : 2607:8xxx:4xx:3xxx::5004/64 Default Ipv6 Gateway : 2607:8xxx:4xx:3xxx::252 SSH Remote Logins : enabled [Manager Config] Manager IP addr : 2607:8xxx:4xx:3xxx::5003 (primary intf) RSA Key Size : 2048 Install TCP Port : 8501 Alert TCP Port : 8502 Logging TCP Port : 8503
Applicable to:
NS-series Sensors and Virtual IPS Sensors