Upon execution, this command displays all the current configuration settings on the Sensor, such as the model, installed software version, IP address, and Manager details.
This command has no parameters.
Syntax:
show
Information displayed by the show command includes the following:
[Sensor Info]
System Name
Date
System Uptime
System Type
System serial number (displays the primary, secondary and master/system serial numbers separately in case of NS9300)
Software Version
Hardware Version
MGMT Ethernet Port
MGMT port Link Status
[Sensor Network Config]
IP Address
Netmask
Default Gateway
SSH Remote Logins
[Manager Config]
Self Signed cert support
Install TCP Port
Alert TCP Port
Logging TCP Port
CA Signed cert support
Install TCP Port
Alert TCP Port
Logging TCP Port
FIPS Mode
Admin SSH/Console Access
Sample Output:
For Sensor, the output is as shown:
intruShell@NS3200_FIPS> show
[Sensor Info] System Name : NS3200_FIPS
Date : 1/15/2024 - 16:1:3 UTC
System Uptime : 41 days 21 hrs 34 min 46 secs
System Type : IPS-NS3200
System Mode : Standalone
Serial Number : 0123456789
Software Version : 11.1.17.x
Hardware Version : 1.10
MGMT Ethernet port : auto negotiated
MGMT port Link Status : link up
[Sensor Network Config]
IP Address : 10.x.x.x
Netmask : 255.255.255.0
Default Gateway : 10.x.x.x
Default SCPserver : 10.x.x.x
SSH Remote Logins : enabled
[Manager Config]
Manager IP addr : 10.x.x.x (primary intf)
Install TCP Port : 8501
Alert TCP Port : 8502
Logging TCP Port : 8503
FIPS Mode : Enabled
Admin SSH/Console Access: Enabled