--- title: "show autorecovery status" slug: "show-autorecovery-status-3" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:52Z published: 2026-11-19T12:29:52Z canonical: "docs.trellix.com/show-autorecovery-status-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # show autorecovery status On encountering data path errors, the Sensor goes Layer 2 mode and tries to auto-recover. During a datapath error, the auto-recovery feature reboots the datapath threads without any interruption to traffic. > [!NOTE] > Note > > The Sensor should be in good health and in Layer 2 mode for performing the auto-recovery. If the recovery is successful, the Sensor comes out of Layer 2 mode. If the recovery is not successful, the Sensor remains in Layer 2 mode. **Syntax:** `show autorecovery status` This command has no parameters. By executing the command, the following status information is displayed: | Status | Description | | --- | --- | | Auto-recovery enabled | The status of auto-recovery, whether it is **On** or **Off**. When the Layer 2 is enabled, this status will be displayed as **On**. | | Auto-recovery attempts | Number of auto-recovery attempts made since last reboot | | Last Auto-recovery status | - **Not applicable** - No auto-recovery is attempted - **Success** - Successful auto-recovery - **Failure** - Failure in auto-recovery - **In Progress** - Auto-recovery in progress | | Last Auto-recover time | The time when Sensor came out of Layer 2 due to successful auto-recovery | **Applicable to:** NS-series Sensors > [!NOTE] > Note > > Auto-recovery is supported on Virtual IPS Sensors. However, a Virtual IPS Sensor cannot depend on its software to go to Layer 2 during recovery. So, the traffic is interrupted until all applications are restarted and the Sensor is back to good health.