This command shows whether failover is enabled on the Sensor, the status of the peer Sensor, and the fail-open action of the Sensor.
Syntax:
show failover-status
Information displayed by the show failover-status command includes the following:
Failover Enabled: The command will return -
YES: If failover is enabled
NO: If failover is disabled
UNKNOWN: If it is not explicitly set
Peer Status: Shows if failover is enabled, and whether the peer Sensor is UP or DOWN
Fail-open Action: Shows whether the monitoring port for fail-open is enabled or disabled
Note
When you enable fail-open on a HA pair, the same monitoring ports are enabled for fail-open on both the primary and secondary Sensors.
Applicable to:
NS-series Sensors