--- title: "show interfaces <portName>" slug: "show-interfaces-portname" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:22:31Z published: 2026-08-04T17:22:31Z canonical: "docs.trellix.com/show-interfaces-portname" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # show interfaces <portName> When the supported appliance is operating in layer 3 mode, this command displays the status and traffic statistics for the specified monitoring port. > [!NOTE] > Note > > The following Network Security virtual appliances support layer 3 mode: NX 2500V, NX 2501V, NX 2550V, NX 4500V, and NX 6500V. You can also view a brief summary of the status information (no traffic statistics) or just the interface configuration. ### Syntax `show interfaces <portName> [brief | configured]` ### Parameters `<portName>` The monitoring port, such as pether3, for which the status and traffic statistics are to be dfisplayed. `brief` (Optional) Displays a brief summary of the status information (no traffic statistics). `configured` (Optional) Displays just the configured settings for the enabled interfaces. ### Examples The following commands show that pether3 and pether4 are mapped to network namespace vrfA. In this example, static routes have not yet been configured for vrfA. ``` hostname (config) # show interfaces pether3 brief Interface pether3 status:   Comment:   Admin up:           yes   Link up:            yes   DHCP running:       no   IP address:             Netmask:               IPv6 enabled:       no   Speed:              10000Mb/s   Duplex:             full   Interface type:     ether   Interface ifindex:  23   Interface source:   physical   Interface namespace:vrfA   MTU:                1600   HW address:         00:50:56:01:2F:A1 ``` ``` hostname (config) # show interfaces pether4 brief Interface pether4 status:   Comment:   Admin up:           yes   Link up:            yes   DHCP running:       no   IP address:             Netmask:               IPv6 enabled:       no   Speed:              10000Mb/s   Duplex:             full   Interface type:     ether   Interface ifindex:  24   Interface source:   physical   Interface namespace:vrfA   MTU:                1600   HW address:         00:50:56:01:2F:A2 ``` ### Supported appliances This command is supported on the following appliance running the specified release or later: - **Network Security:** Release 9.0