--- title: "show interfaces" slug: "show-interfaces" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:22:31Z published: 2026-08-04T17:22:31Z canonical: "docs.trellix.com/show-interfaces" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # show interfaces Displays the status and traffic statistics for one or all interfaces. You can also view a brief summary of the status information (no traffic statistics) or just the interface configuration. > [!NOTE] > Note > > Monitoring (*pether3* to *pether_n*) ports are not displayed using the **show interfaces** command. To see the status of these ports, use the **show interfaces *name*** command. ### Syntax show interfaces [name] [brief | configured] ### Parameters | *name* | Interface name (such as “ether1,” “tap0,” or “lo” for loopback). | | --- | --- | | brief | Displays a brief summary of the status information (no traffic statistics). | | **configured** | Displays just the configured settings for the enabled interfaces. | ### Examples The following example shows status and traffic statistics for all interfaces. ``` hostname # show interfaces ``` ``` Interface ether1 state  Admin up:           yes  Link up:            yes  IP address:         192.168.0.69  Netmask:            255.255.255.0  Speed:              1000Mb/s (auto)  Duplex:             full (auto)  Interface type:     ethernet MTU:                1500 HW address:         00:0C:29:5D:D7:28 ``` ``` RX bytes:           11668267 RX packets:         107222RX mcast packets:   0 RX discards:        0 RX errors:          0 RX overruns:        0 RX frame:           0 ``` ``` TX bytes:           4458023 TX packets:         13155 TX discards:        0 TX errors:          0 TX overruns:        0 TX carrier:         0 TX collisions:      0 ``` ``` Interface ether2 state Admin up:           yes Link up:            yes ``` The following example shows status and traffic statistics for the pether3 interface. ``` hostname # show interfaces pether3 ``` ### Supported appliances This command was released as follows: - **Endpoint Security (HX)**: Release 2.5