--- title: "show intfport" slug: "show-intfport-4" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:07Z published: 2026-11-19T12:30:07Z canonical: "docs.trellix.com/show-intfport-4" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # show intfport This command shows the status of the specified Sensor port. Note that specifying a non-existent port results in an error. **Syntax:** `show intfport <port>` | Parameter | Description | | --- | --- | | | Sets the port for which the status is to be displayed. Valid port numbers for NS-series Sensors (except NS3600) are: g0/1 \| g0/2 \| g1/1 \| g1/2 \| g1/3 \| g1/4 \| g1/5 \| g1/6 \| g1/7 \| g1/8 \| g1/9 \| g1/10 \| g1/11 \| g1/12 \| g2/1 \| g2/2 \| g2/3 \| g2/4 \| g2/5 \| g2/6 \| g2/7 \| g2/8 \| g2/9 \| g2/10 \| g2/11 \| g2/12 \| g3/1 \| g3/2 \| g3/3 \| g3/4 \| g3/5 \| g3/6 \| g3/7 \| g3/8 \| WORD \| all Valid port-pairs for NS3600 Sensor are: 1-2 \| 3-4 \| 5-6 \| 7-8 \| 9-10 \| 11-12 \| 13-14 | Information displayed by the `show intfport` command includes the following: - Whether the port's administrative status is enabled or disabled - The Sensor's operational status - The Sensor's operating mode - Whether full-duplex mode is enabled - The port's configured traffic direction (inside or outside) - The speed of the 10/100 ports, if applicable - The speed of the Gigabit ports, if applicable - The peer port's supported link mode - The peer ports negotiated duplex and speed - The auto-negotiating configuration - Total packets received - Total packets sent - Total CRC errors received - Total CRC errors sent - Whether the flow control is on (this applies only to Sensor gigabit ports) **Sample Output:** For Sensors, the output is as shown below: `intruShell@john> show intfport g1/2` `Displaying port g1/2` `Administrative Status : ENABLED (since Thu Jan 5 03:36:51 2023)` `Operational Status : UP (since Thu Jan 5 03:38:02 2023)` `Operating Mode : INLINE_FAIL_OPEN_ACTIVE` `Duplex : FULL` `Port Connected to : OUTSIDE` `Port Speed : 10 GBPS` `Actual Port Property : Fiber, Trellix Certified` `Configured Port Property: Fiber, Allow any vendor certified connector` `Additional Porttype Info:` `Total Packets Received : 882391` `Total Packets Sent : 882191` `Total CRC Errors Rcvd : 0` `Total Other Errors Rcvd : 0` `Total CRC Errors Sent : 0` `Total Other Errors Sent : 0` `Flow Control Status : OFF` `Fail-Open Switch : PRESENT` `Fail-Open Port : INLINE` `Layer 2 Status : DISABLED` **Applicable to:** NS-series and Virtual IPS Sensors. The command does not apply to Virtual Security System instances; use the `show ingress-egress stat` command instead.