This command displays the channel used by Sensor to communicate with Intelligent Sandbox.
By default, SSL channel is used. You can switch between TCP and SSL channel to send files for scanning.
Syntax:Note
For TCP channel, make sure that the listening port 8506 is set on Intelligent Sandbox. From an ATD appliance, execute the set nsp-tcp-channel CLI command to enable or disable TCP channel.
show matd channel
Sample output:
IntruDbg#> show matd channel
MATD NSP channel type:SSL
IntruDbg#> show matd channel
MATD NSP channel type:TCP
Applicable to:
NS-series Sensors