The show mgmtport command displays all the current configuration settings for the Sensor Management port.
This command has no parameters.
Syntax:
show mgmtport
Information displayed by the show mgmtport command includes the following:
- The Sensor's Management port value (10000Mbps, 1000Mbps, 100Mbps, or auto-negotiate)
- The Sensor's Management port link status (what speed the two devices settled upon—typically the highest common setting)
- What mode has been settled upon
- The link status
- The capabilities of the Management port (possible values are: 10000baseTx-FD, 1000baseTx-FD, 100baseTx-FD, 100baseTx-HD)
- What the Management port is advertising its capabilities as (possible values are: 10000baseTx-FD, 1000baseTx-FD, 100baseTx-FD, 100baseTx-HD)
- The characteristics of its link partner (possible values are: 10000baseTx-FD, 1000baseTx-FD, 100baseTx-FD, 100baseTx-HD)
Sample Output:
For Sensor, the output is as shown below:
intruShell@john> show mgmtport
MGMT Ethernet port : auto negotiated
Settings for MGMT port :
Supported link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Auto-negotiation: on
Link detected: yes
eth0 Link encap:Ethernet HWaddr 00:1E:67:BB:B3:B1
inet addr:10.208.15.91 Bcast:0.0.0.0 Mask:255.255.255.0
inet6 addr: fe80::21e:67ff:febb:b3b1/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:13164765 errors:0 dropped:1216912 overruns:0 frame:0
TX packets:1886946 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7487476603 (7140.6 Mb) TX bytes:175263884 (167.1 Mb)
Applicable to:
NS-series Sensors