--- title: "show ntp" slug: "show-ntp" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:23:09Z published: 2026-08-04T17:23:09Z canonical: "docs.trellix.com/show-ntp" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # show ntp Displays the current NTP runtime state and configuration. ### Syntax ``` show ntp ``` ### Parameters None ### Output fields The following table describes the output fields for this command. | Field | Description | | --- | --- | | Address | The IP address of the time source (NTP server or peer). | | auth | The NTP authentication status: **ok**—The authentication succeeded. **bad**—An authentication key is configured, but the authentication failed. **none**—No authentication key is mapped to the NTP server. **n/a**—An authentication key is configured, but the server is not reachable yet. | | Stratum | A value that denotes the relative distance from the reference clock, which is a stratum-0 device. A stratum-1 server receives its time from the reference clock, a stratum-2 server receives its time from a stratum-1 server, and so on. | | Offset (msec) | The offset between the system clock and the time source, in milliseconds. | | Ref Clock | The IP address of the reference clock of the time source. | | Poll Interv (sec) | The number of seconds between NTP poll packets. | | Last Resp (sec) | The number of seconds since the last response to a poll was received. | ### Example The following example shows the current NTP runtime state and configuration. ``` hostname > show ntp NTP is administratively enabled. NTP Authentication is administratively enabled. Clock is synchronizated. Reference: 10.255.34.6 Offset: 1.713 ms. Active servers and peers:                                                           Poll    Last                                       Offset  Ref         Interv  Resp Address      auth  Status     Stratum  (msec)  Clock       (sec)   (sec) ======================================================================= 192.168.1.1  none  candidat (+)  2     -0.233  10.2.3.4     64     60 10.2.3.4     none  outlyer  (-)  2     12.069  192.168.2.2  64     50 172.16.4.5   none  candidat (+)  2     -0.958  10.5.6.7     64     50 10.255.34.6  none  sys.peer (*)  2     1.713   172.16.3.4   64     45 ``` ### User role Admin, Operator, or Monitor ### Command mode Enable ### Supported appliances This command is supported on the following appliances running the specified releases or later: - **Malware Analysis**: Before release 6.4 - **Central Management System**: Before release 6.4 - **Email Security — Server** :Before release 6.4. The `NTP Authentication` output line was introduced in EX Series Release 7.8.0. The `auth` output column replaced the `Conf Type` column in Email Security — Server Release 7.8.0. - **File Protect**: Before release 6.4 - **Endpoint Security (HX)**: Release 2.5 - **Network Security**: Before release 6.4