This command displays all the current configuration settings for the Sensor Response port.
This command has no parameters.
Syntax:
show respport r1
On executing the command, the information displayed in the output includes the following:
- The Sensor's Response port value (1000Mbps, 100Mbps, 10Mbps, or auto-negotiate)
- The Sensor's Response port link status (what speed the two devices settled upon—typically the highest common setting)
- What mode has been settled upon
- The link status
- Statistics for the Response port
Sample Output:
intruShell@john> show respport r1
Response Ethernet port : auto negotiated
Settings for MGMT port :
Supported link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: Unknown!
Duplex: Unknown! (255)
Auto-negotiation: on
Link detected: no
eth1 Link encap:Ethernet HWaddr 00:1E:67:58:9E:3F
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Response Port Statistics
Total Packets Sent : 0
Applicable to:
NS-series Sensors