--- title: "show respport r1" slug: "show-respport-r1-3" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:07Z published: 2026-11-19T12:30:07Z canonical: "docs.trellix.com/show-respport-r1-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # show respport r1 This command displays all the current configuration settings for the Sensor Response port. This command has no parameters. **Syntax:** `show respport r1` On executing the command, the information displayed in the output includes the following: - The Sensor's Response port value (1000Mbps, 100Mbps, 10Mbps, or auto-negotiate) - The Sensor's Response port link status (what speed the two devices settled upon—typically the highest common setting) - What mode has been settled upon - The link status - Statistics for the Response port **Sample Output:** `intruShell@john> show respport r1` `Response Ethernet port : auto negotiated` `Settings for MGMT port :` `Supported link modes: 100baseT/Full` `1000baseT/Full` `10000baseT/Full` `Advertised link modes: 100baseT/Full` `1000baseT/Full` `10000baseT/Full` `Advertised pause frame use: No` `Advertised auto-negotiation: Yes` `Speed: Unknown!` `Duplex: Unknown! (255)` `Auto-negotiation: on` `Link detected: no` `eth1 Link encap:Ethernet HWaddr 00:1E:67:58:9E:3F` `UP BROADCAST MULTICAST MTU:1500 Metric:1` `RX packets:0 errors:0 dropped:0 overruns:0 frame:0` `TX packets:0 errors:0 dropped:0 overruns:0 carrier:0` `collisions:0 txqueuelen:1000` `RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)` `Response Port Statistics` `Total Packets Sent : 0` **Applicable to:** NS-series Sensors