This command displays all the current configuration settings for the Sensor Response port.
This command has no parameters.
Syntax:
show respport r1
On executing the command, the information displayed in the output includes the following:
The Sensor's Response port value (1000Mbps, 100Mbps, 10Mbps, or auto-negotiate)
The Sensor's Response port link status (what speed the two devices settled upon—typically the highest common setting)
What mode has been settled upon
The link status
Statistics for the Response port
Sample Output:
intruShell@john> show respport r1
Response Ethernet port : auto negotiated
Settings for MGMT port :
Supported link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: Unknown!
Duplex: Unknown! (255)
Auto-negotiation: on
Link detected: no
eth1 Link encap:Ethernet HWaddr 00:1E:67:58:9E:3F
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Response Port Statistics
Total Packets Sent : 0
Applicable to:
NS-series Sensors