--- title: "show respport r1" slug: "show-respport-r1" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:41:06Z published: 2026-10-05T15:41:06Z canonical: "docs.trellix.com/show-respport-r1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # show respport r1 This command displays all the current configuration settings for the Sensor Response port. This command has no parameters. **Syntax:** show respport r1 On executing the command, the information displayed in the output includes the following: - The Sensor's Response port value (1000Mbps, 100Mbps, 10Mbps, or auto-negotiate) - The Sensor's Response port link status (what speed the two devices settled upon—typically the highest common setting) - What mode has been settled upon - The link status - Statistics for the Response port **Sample Output:** intruShell@john> show respport r1 Response Ethernet port : auto negotiated Settings for MGMT port : Supported link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full Advertised link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full Advertised pause frame use: No Advertised auto-negotiation: Yes Speed: Unknown! Duplex: Unknown! (255) Auto-negotiation: on Link detected: no eth1 Link encap:Ethernet HWaddr 00:1E:67:58:9E:3F UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) Response Port Statistics Total Packets Sent : 0 **Applicable to:** NS-series Sensors