This show sensor-load command shows you the following information:
- Average of load (traffic) seen on all processing elements
- Maximum of load (traffic) seen on a single processing element
Syntax:
show sensor-load
Sample Output:
On executing the command, the following messages are displayed:
- When the Sensor-load in ON
intruShell@john> show sensor-load
Average load across all PEs : 0% (approx.)
Maximum load on a single PE : 0% (approx.)
- When the Sensor-load is OFF
CPU usage tracking is currently disabled. It can be enabled on the Advanced Device Settings page of the Manager GUI.
Applicable to:
NS-series Sensors