Signature or software update status

To see if your Sensor successfully received a signature update or software upgrade, you can use the status command as shown in the following procedure, or the downloadstatus command, described later in this chapter.

To use the status command:

On the Sensor, type status at the command prompt before updating the signature set on the Sensor. Note the signature version.
Update the signature set on the Sensor using the Manager screens.
On the Sensor, again type status at the command prompt after the update from Manager is complete. Verify that the signature version number has incremented. The new signature version should match with the signature set version that has been updated from the Manager and applied to the Sensor.