--- title: "Single-interface LAN configuration" slug: "single-interface-lan-configuration-1" tags: ["Central Management System", "Install and Get Started"] updated: 2026-10-01T11:29:05Z published: 2026-10-01T11:29:28Z canonical: "docs.trellix.com/single-interface-lan-configuration-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Single-interface LAN configuration This configuration is similar to the default configuration because it uses a single interface, but it does not use ether1 as the default HA interface. IP routing is not needed, because the two nodes are in the same subnet. - [Configuring the single-interface LAN option using the wizard](/network-and-platform/docs/configuring-the-single-interface-lan-option-using-the-wizard) - [Configuring the single-interface LAN option using the CLI](/network-and-platform/docs/configuring-the-single-interface-lan-option-using-the-cli) ### Prerequisites - Admin access - Requirements listed in [Basic requirements](/network-and-platform/docs/system-requirements-3#basic_requirements) - Physical Central Management System models: - Cable or switch requirement listed in [LAN deployment requirements](/network-and-platform/docs/system-requirements-3#lan_deployment_requirements) - Non-default interface requirements listed in [LAN deployment requirements](/network-and-platform/docs/system-requirements-3#lan_deployment_requirements) - Virtual Central Management System models: - Virtual network configured as described in [Virtual network requirements](/network-and-platform/docs/virtual-central-management-system-network-requirements-1) :