Adds a range of IP addresses to the data exfiltration detection whitelist on a SmartVision appliance.
SmartVision appliances are described in the Network Security SmartVision Feature Guide.
The data exfiltration detection whitelist specifies the destination IP address ranges for which the SmartVision appliance does not generate data exfiltration alerts. The whitelist is empty by default.
Note
You can also run this command remotely from the command line of an integrated Trellix Central Management System appliance using the central management appliance proxying mechanism.
Syntax
[no] smartvision exfil whitelist <ip address>/<prefix>
Parameters
no
Use the no form of the command to remove the specified range of IP addresses from the data exfiltration detection whitelist.
<ipAddress>
The destination IPv4 or IPv6 address range for which the SmartVision appliance does not generate data exfiltration alerts.
<prefix>
The length of the IP address subnet mask.
Example
hostname (config) # smartvision exfil whitelist 192.168.4.0/2
Command mode
Config
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Network Security: Release 8.0