--- title: "smartvision exfil whitelist <ip address>/<prefix>" slug: "smartvision-exfil-whitelist-ip-address-prefix" tags: ["Reference", "CMS 11.x", "EX 11.x", "HX 10.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-08-04T17:22:31Z published: 2026-08-04T17:22:31Z canonical: "docs.trellix.com/smartvision-exfil-whitelist-ip-address-prefix" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # smartvision exfil whitelist <ip address>/<prefix> Adds a range of IP addresses to the data exfiltration detection whitelist on a SmartVision appliance. SmartVision appliances are described in the Network Security SmartVision Feature Guide. The data exfiltration detection whitelist specifies the destination IP address ranges for which the SmartVision appliance does not generate data exfiltration alerts. The whitelist is empty by default. > [!NOTE] > Note > > You can also run this command remotely from the command line of an integrated Trellix Central Management System appliance using the central management appliance proxying mechanism. ### Syntax `[no] smartvision exfil whitelist <ip address>/<prefix>` ### Parameters `no` Use the `no` form of the command to remove the specified range of IP addresses from the data exfiltration detection whitelist. `<ipAddress>` The destination IPv4 or IPv6 address range for which the SmartVision appliance does not generate data exfiltration alerts. `<prefix>` The length of the IP address subnet mask. ### Example ``` hostname (config) # smartvision exfil whitelist 192.168.4.0/2 ``` ### Command mode Config ### Supported appliances This command is supported on the following appliances running the specified releases or later: - **Network Security:** Release 8.0