---
title: "Stateless Scanning Exceptions"
slug: "stateless-scanning-exceptions"
tags: ["Product Usage", "IPS 10.1.10"]
updated: 2026-09-06T12:31:10Z
published: 2026-10-05T15:41:20Z
canonical: "docs.trellix.com/stateless-scanning-exceptions"
---
> ## Documentation Index
> Fetch the complete documentation index at: https://docs.trellix.com/llms.txt
> Use this file to discover all available pages before exploring further.
# Stateless Scanning Exceptions
The Scanning exceptions feature bypasses the scanning of traffic from a configured VLAN, TCP, or UDP port. The scanning exceptions configurations that are defined can be enabled or disabled at the Sensor level.
> [!NOTE]
> Note
>
> Scanning exception feature rules are applied to both the Sensors in a fail-over pair. On creating a fail-over pair, the template Sensor rules are copied to the peer Sensor.
Prior to 6.1, this feature was supported using the following Sensor CLI commands:
- layer2 forward tcp <enable | disable><0-65535>[<0-65535>]
- layer2 forward udp <enable | disable><0-65535>[<0-65535>]
- layer2 forward vlan <enable|disable> <0-4095> [<0-4095>]
- layer2 forward vlan <enable|disable> <0-4095>[<0-4095>] <interface <all|interfaceA-interfaceB>>
- layer2 forward clear
Scanning Exceptions feature is supported only in the following Sensor models:
- M-8000
- M-6050
- M-4050
- M-3050
- M-2950
- M-2850
- NS9300
- NS9200
- NS9100
- NS7350
- NS7250
- NS7150
- NS7300
- NS7200
- NS7100
- NS5200
- NS5100
- NS3200
- NS3100
Following models does not support the Scanning Exception feature:
- M-1450
- M-1250
- NS3500
> [!NOTE]
> Note
>
> Scanning exceptions rules can be configured on ports running in inline mode. Once set, these rules take precedence over Firewall access rules. Fail-over ports and M-8000 interconnect ports cannot be configured for scanning exceptions