The status command shows Sensor system status, such as System Health, Manager communication, signature set details, total number of alerts detected, and total number of alerts sent to the Manager.
This command has no parameters.
Syntax:
status
Sample Output:
For Sensor, the output is as shown:
[Sensor]
System Initialized : yes
System Health Status : good
Layer 2 Status : normal (IDS/IPS)
Installation Status : opening channel in progress
IPv6 Status : Dont Parse and Allow Inline
Reboot Status : Not Required
Guest Portal Status : up
Hitless Reboot : Available
Last Reboot reason : resetconfig issued from CLI
[Signature Status]
Present : yes
Version : 9.8.20.2
Geo Location database : Present
DAT file : Present
DAT file Version : 2047.0
[Manager Communications]
Trust Established : no
Alert Channel : down
Log Channel : down
Authentication Channel : down
Last Error : Alert Channel - unknown: 13
Alerts Sent : 0
Logs Sent : 0
[Alerts Detected]
Signature : 0 Alerts Suppressed : 0
Scan : 0 Denial of Service : 0
Malware : 0
[MATD Communication]
Status : down
IP : 0.0.0.0
Port(Secure) : 8505
FIPS Mode : Enabled
Admin SSH/Console Access: Enabled
Note
If there is a failure in establishing trust relationship between the Sensor and Manager due to mismatch in shared secret key, the Last Error displays the message Alert Channel - Install Keys Mismatch. In such an instance, check the shared secret key on the Manager and set it on the Sensor using set sensor sharedsecretkey command.
Applicable to:
NS-series Sensors