--- title: "status" slug: "status-1" tags: ["Reference", "IPS 10.1.10"] updated: 2026-09-23T09:41:20Z published: 2026-09-23T09:41:20Z canonical: "docs.trellix.com/status-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # status The status command shows Sensor system status, such as System Health, Manager communication, signature set details, total number of alerts detected, and total number of alerts sent to the Manager. This command has no parameters. **Syntax:** status **Sample Output:** For Sensor, the output is as shown: [Sensor] System Initialized : yes System Health Status : good Layer 2 Status : normal (IDS/IPS) Installation Status : opening channel in progress IPv6 Status : Dont Parse and Allow Inline Reboot Status : Not Required Guest Portal Status : up Hitless Reboot : Available Last Reboot reason : resetconfig issued from CLI [Signature Status] Present : yes Version : 9.8.20.2 Geo Location database : Present DAT file : Present DAT file Version : 2047.0 [Manager Communications] Trust Established : no Alert Channel : down Log Channel : down Authentication Channel : down Last Error : Alert Channel - unknown: 13 Alerts Sent : 0 Logs Sent : 0 [Alerts Detected] Signature : 0 Alerts Suppressed : 0 Scan : 0 Denial of Service : 0 Malware : 0 [MATD Communication] Status : down IP : 0.0.0.0 Port(Secure) : 8505 FIPS Mode : Enabled Admin SSH/Console Access: Enabled > [!NOTE] > Note > > If there is a failure in establishing trust relationship between the Sensor and Manager due to mismatch in shared secret key, the Last Error displays the message Alert Channel - Install Keys Mismatch. In such an instance, check the shared secret key on the Manager and set it on the Sensor using set sensor sharedsecretkey command. **Applicable to:** NS-series Sensors