This command displays Sensor system status, such as System Health, Manager communication, signature set details, total number of alerts detected, and total number of alerts sent to the Manager.
This command has no parameters.
Syntax:
status
Sample Output:
For Sensor, the output is as shown below:
intruShell@john> status
[Sensor]
System Initialized : yes
System Health Status : good
System Capacity : 750 Mbps
Note
System Capacity is displayed only for NS9600, NS9500, NS7600, NS7500, NS3600, and NS3500 Sensors.
Layer 2 Status : normal (IDS/IPS)
Installation Status : complete
IPv6 Status : Parse and Detect Attacks
Reboot Status : Not Required
Guest Portal Status : up
Hitless Reboot : Not-Available
Last Reboot reason : reboot issued from CLI
Mode Change Status : Not-Applicable
[Signature Status]
Present : yes
Version : 11.9.0.5
Power up signature : good
Geo Location database : Present
DAT file : Present
Version : 3376.0
[Manager Communications]
Trust Established : yes (Self Signed cert support)
Alert Channel : up
Log Channel : up
Authentication Channel : up
Last Error : None
Alerts Sent : 961
Logs Sent : 974
[Alerts Detected]
Signature : 4246 Alerts Suppressed : 3483
Scan : 0 Denial of Service : 2
Malware : 4
[NTBA Communication]
Status : up
IP : 10.213.174.132
Port : 8505
[TIS Communication]
Status : up
IP : 10.200.100.60
Port(Secure) : 8505
The same status message appears in an NTBA Appliance also.
Note
In NS9300 Sensor, if the Sensor reboots due to mismatch in software version, the
statuscommand specifies the reasonrecovered from sw version mismatchinLast Reboot reason.
Note
For NS9600, NS9500, and NS3500 Sensors, the
statuscommand also displays the current throughput based on the license purchased. If signature set is not detected in the Sensor,No licenseis displayed.
Note
If there is a failure in establishing trust between the Sensor and Manager due to mismatch in shared secret key, the
Last Errordisplays the messageAlert Channel - Install Keys Mismatch. In such an instance, check the shared secret key on the Manager and set it on the Sensor usingset sensor sharedsecretkeycommand.
Applicable to:
NS-series Sensors