--- title: "Synchronizing configuration settings using the CLI" slug: "synchronizing-configuration-settings-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-12T20:32:10Z published: 2026-09-12T20:32:10Z canonical: "docs.trellix.com/synchronizing-configuration-settings-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Synchronizing configuration settings using the CLI Use the commands in this section to synchronize configuration settings from one appliance in an HA pair to the peer appliance. ### Note All mismatched settings are synchronized with the source appliance at the same time. If necessary, you can manually adjust individual settings later. To synchronize the configuration: 1. Log in to the Central Management System CLI. 2. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal hostname (config) # ``` 3. Synchronize the configuration from either appliance: ``` hostname (config) # cmc ha nx sync config with ``` where `<pair>` is the name of the HA pair, `<sourceAppliance>` is the name of the appliance whose settings you want to keep, and `<targetAppliance>` is the name of the appliance whose settings you want to update. (The appliance name is displayed in the `show cmc appliances` command output). 4. Verify that the appliance configuration is synchronized: ``` hostname (config) # show cmc ha nx ``` 5. Save your changes: ``` hostname (config) # write memory ``` ##### Example The following example uses the nx-2 appliance settings to synchronize the configuration settings on the Acme_NXHA pair. For example, if the NTP (Network Time Protocol) servers do not match, this command overwrites the nx-1 NTP server settings with the nx-2 settings. ``` hostname (config) # cmc ha nx Acme_NXHA sync nx-1 config with nx-2 Configuration is synced with nx-2 successfully hostname (config) # show cmc ha nx Acme_NXHA ... ``` :