--- title: "Synchronizing the system clock to DTI server time using the CLI" slug: "synchronizing-the-system-clock-to-dti-server-time-using-the-cli-6" tags: ["Product Usage", "CMS 11.x", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Customer", "Network Security"] updated: 2026-09-07T20:58:07Z published: 2026-09-07T20:58:07Z canonical: "docs.trellix.com/synchronizing-the-system-clock-to-dti-server-time-using-the-cli-6" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Synchronizing the system clock to DTI server time using the CLI The system time should match the DTI server time as closely as possible. This is necessary for features such as the license update service, in which licenses are downloaded from the DTI server and installed on the Malware Analysis appliance. > [!WARNING] > Important > > To prevent time gaps that could affect the validity of your licenses, Trellix recommends that you perform this synchronization before you enable the feature. The `fenet time sync` CLI command retrieves the time (in UTC) from the DTI server and then synchronizes the system clock to it. This command is especially useful if you do not use NTP servers to synchronize your system clock. > [!WARNING] > Important > > This action synchronizes the system clock to the DTI server a single time. It does not change the system time zone. **Prerequisites** - Admin access **To synchronize the system clock to the DTI server clock:** 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Synchronize the clocks: ``` hostname (config) # fenet time sync ``` 3. Save your changes: ``` hostname (config) # write memory ```