--- title: "The IPS Sensor interface node" slug: "the-ips-sensor-interface-node" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-09-06T12:28:08Z published: 2026-10-05T15:41:20Z canonical: "docs.trellix.com/the-ips-sensor-interface-node" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # The IPS Sensor interface node The **Interface-x** nodes under **IPS Interfaces** represent an interface (a single physical port, peer ports, or an interface group) on a particular Sensor. The number of interface nodes displayed depends upon the type of Sensor. Interface nodes are displayed individually by default because the default monitoring mode is SPAN mode. Full-duplex Tap and Inline modes require two physical ports, and each mode uses these two ports to form a single logical interface. Therefore, all configuration and policy decisions are made at a logical interface level. After a new Sensor is installed, a policy is inherited from the admin domain and enforced on all Sensor interfaces. Subinterfaces are user created within this resource, and can be edited here or from the **Sub-interface-x** resource node. > [!NOTE] > Tip > > Interfaces can be allocated to child domains for specialized management. The navigation path to the interface nodes is as follows: 1. Click the **Devices** tab. 2. Select the domain from the **Domain** drop-down list. 3. On the left pane, click the **Devices** tab. 4. Select the device from the **Device** drop-down list. 5. For a standalone Sensor, select **IPS Interfaces** → ****. For Sensors in a stack, select **IPS Interfaces** → **** → ****. The primary tasks that you can perform are customizing policies, assigning policies, and configuring inspection options.