--- title: "To define the submission interface:" slug: "to-define-the-submission-interface" tags: ["Product Usage", "IVX Cloud", "Sec Ops and Analytics"] updated: 2026-09-04T14:05:43Z published: 2026-09-04T14:05:43Z canonical: "docs.trellix.com/to-define-the-submission-interface" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # To define the submission interface: 1. Log in to the sensor CLI. 2. Enable the CLI configuration mode: hostname > **enable** hostname # **configure terminal** 3. Specify the interface: hostname (config) # **mvx sensor config submission-if** 4. *If the sensor and cloud broker are in different subnets*: Specify the IPv4 address of the default gateway for the interface: hostname (config) # **mvx sensor config submission-if** **default-gateway ipv4** 5. Verify your change: hostname (config) # **show mvx status** 6. hostname (config) # **show mvx status** hostname (config) # **write memory** **Example** The following example defines ether2 as the submission interface on the nx-4 sensor. ``` nx-4 (hostname) # mvx node config submission-if ether2 nx-4 (hostname) # show mvx status MVX Mode Status:    Sensor Config Enabled: yes    Current Operating Mode: sensor    Mode Reboot Required: no    Submission Interface: ether2    Modes Supported: mvx configurable    ... ``` :