--- title: "Troubleshooting the Sensor" slug: "troubleshooting-the-sensor-7" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:52Z published: 2026-09-17T09:43:52Z canonical: "docs.trellix.com/troubleshooting-the-sensor-7" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Troubleshooting the Sensor This section lists some common installation problems, the possible causes, and the corresponding solutions. | Problem | Possible Cause | Solution | | --- | --- | --- | | LED is off. | The Sensor is turned off. | Restore Sensor power. | | LED is off. | The Sensor port cable is disconnected. | Check the Sensor cable connections. | | Sensor is operational but is not monitoring traffic. | Network device cables have been disconnected. | Check the cables and make sure they are properly connected to both the network devices and the bypass switch. | | Sensor is operational but is not monitoring traffic. | The Sensor ports have not been enabled in the Manager. | The Sensor will not monitor traffic on the ports unless the ports are enabled in the Manager. Ports are disabled in case of Sensor failure; you must re-enable them for Sensor monitoring to resume. | | Network or link problems | Improper cabling or port configuration | Make sure that the transmitting and receiving cables are properly connected to the bypass switch. | | Runts or giants errors on switch and routers | Improper cabling or port configuration | Make sure that the transmitting and receiving cables are properly connected to the bypass switch. | | The system fault "Switch absent" appears in the Manager Status page. | The Active Fail-Open Kit is disconnected. | Check the Active Fail-Open Kit and make sure it is properly connected to the Sensor. |