--- title: "Troubleshooting user-based access rules" slug: "troubleshooting-user-based-access-rules-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:30:20Z published: 2026-11-19T12:30:20Z canonical: "docs.trellix.com/troubleshooting-user-based-access-rules-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Troubleshooting user-based access rules The following are some points that you can consider to troubleshoot issues related to user-based access rules: - Make sure that above your user-based access rules, there are rules that allow DNS, DHCP, and AD traffic to the corresponding servers. - If a user-based rule is not working as expected, change the **Source User** to **any** and see if the rule is working fine. - If you are unable to view the users or user groups in the **Firewall** page, check the communication between the Manager and the Trellix Logon Collector. - CLI commands related to user-based access rules: - `show userInfo stats`: Displays the number of full (bulk) updates and incremental updates to the Sensor. Also, displays the number of users, user groups, and host IP addresses currently present in the Sensor. - The Manager raises a fault message for the following conditions : - The Manager is unable to contact Trellix Logon Collector. - The number of IPs to users mapping has exceeded 100,000. - The number of users has exceeded 75,000. - The bulk update from the Manager to the Sensor is more than 25 MB in size. In this case, the fault is raised and the Manager aborts the update. - When the user groups limit exceed the specified values, the following faults are raised: - **AD user groups size exceeded** - **TLC IP-User mapping/ User count exceeds limit** - **TLC Group Size fault** For more information on these faults, refer to [Manager faults](/network-and-platform/docs/manager-faults-2) in the *Troubleshooting* section of this guide.