---
title: "Turning the Sensor on and off"
slug: "turning-the-sensor-on-and-off-4"
tags: ["Hardware", "IPS 11.1.x"]
updated: 2026-09-17T09:43:45Z
published: 2026-09-17T09:43:45Z
canonical: "docs.trellix.com/turning-the-sensor-on-and-off-4"
---
> ## Documentation Index
> Fetch the complete documentation index at: https://docs.trellix.com/llms.txt
> Use this file to discover all available pages before exploring further.
# Turning the Sensor on and off
> [!NOTE]
> Note
>
> Do not attempt to turn on the Sensor until you have installed the Sensor in a rack and made all the necessary network connections.
**Steps:**
1. Connect the power cable to the Sensor power inlet.
2. Connect the power cable to a power source.
> [!NOTE]
> Note
>
> If you are installing a redundant power supply, you should install it as described in Install a new power supply section. For true redundant operation with the optional redundant power supply,Trellix recommends that you plug each supply into a different power circuit.
The Sensor has no power switch. The Sensor turns on as soon as one of its power cables is connected to a power source.
Trellix recommends that you use the `shutdown`CLI command to halt the Sensor before turning it off. For more information on CLI commands, see the CLI commands section in Trellix Intrusion Prevention System Product Guide