--- title: "Turning the Sensor on and off" slug: "turning-the-sensor-on-and-off-7" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:45Z published: 2026-09-17T09:43:45Z canonical: "docs.trellix.com/turning-the-sensor-on-and-off-7" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Turning the Sensor on and off > [!NOTE] > Note > > Do not attempt to turn on the Sensor until you have installed the Sensor in a rack and made all the necessary network connections. **Steps:** 1. Connect the power cable to the Sensor power inlet. 2. Connect the power cable to a power source. > [!NOTE] > Note > > If you are installing a redundant power supply, you should install it as described in Install a new power supply section. For true redundant operation with the power supply,Trellix recommends that you plug each supply into a different power circuit. The Sensor has no power switch. The Sensor turns on as soon as one of its power cables is connected to a power source. Trellix recommends that you use the `shutdown`CLI command to halt the Sensor before turning it off. For more information on CLI commands, see the CLI commands section in Trellix Intrusion Prevention System CLI Guide.