--- title: "Unsubscribing and re-enrolling a sensor or hybrid appliance" slug: "unsubscribing-and-re-enrolling-a-sensor-or-hybrid-appliance" updated: 2026-08-24T20:40:19Z published: 2026-08-24T20:40:19Z canonical: "docs.trellix.com/unsubscribing-and-re-enrolling-a-sensor-or-hybrid-appliance" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Unsubscribing and re-enrolling a sensor or hybrid appliance Use the commands in this section if you need to unsubscribe a sensor or hybrid appliance and then re-enroll it. > [!NOTE] > Note > > You can also use the **Select** > **Un-Enroll And Delete** option on the **Sensors** page of the managing Central Management appliance to unsubscribe a sensor or hybrid appliance when you delete it from the Central Management appliance. ##### To unsubscribe a sensor or hybrid appliance: 1. Unsubscribe the sensor or hybrid appliance: ``` appl-hostname (config) # mvx cluster unenroll now ``` 2. Verify your change: ``` appl-hostname (config) # show mvx cluster enrollment status ``` 3. Save your change: ``` appl-hostname (config) # write memory ``` > [!NOTE] > Note > > If you unsubscribe a sensor or hybrid appliance, it will not be automatically enrolled again, even though the status shows that automatic enrollment is enabled. Use the ivx cluster enroll now command to re-enroll a sensor or hybrid appliance that was unsubscribed using the ivx cluster unenroll now command. ##### To re-enroll a sensor or hybrid appliance: 1. Log in to the sensor or hybrid appliance CLI. 2. Enable the CLI configuration mode: ``` appl-hostname > enable appl-hostname # configure terminal ``` 3. Re-enroll the sensor or hybrid appliance: ``` appl-hostname (config) # mvx cluster enroll now ``` 4. Verify your change: ``` appl-hostname (config) # show mvx cluster enrollment status ``` 5. Save your change: ``` appl-hostname (config) # write memory ``` **Examples** The following example unsubscribes the nx-6 sensor. ``` nx-6 (config) # mvx cluster unenroll now Operation initiated in the background.    Run 'show mvx cluster enrollment status' nx-6 (config) # show mvx cluster enrollment status MVX Cluster Enrollment Status    Enrollment Client :        Status ok             : no        Status description    : unenrolled        Last checked at       : 2019/08/21 00:39:03    Enrollment Service :        Auto enabled          : yes        Service address       : DTI (DTIUser@10.11.121.13 : singleport)        Preferred cluster     : any (less loaded)        Cloud enabled         : yes        Cloud License enabled : yes After you reload the sensor, the status is as follows: nx-6 (config) # show mvx cluster enrollment status Enrollment Client :    Status ok                : no    Status description       : Enrollment Service Unavailable    Last checked at          : 2019/08/21 00:48:30 Enrollment Service :    Auto enabled             : yes    Service address          : CMS (DTIUser@10.11.121.13 : singleport)    Preferred cluster        : any (less loaded) The following example sends a request to enroll the nx-05 sensor. nx-05 (config) # mvx cluster enroll now Operation initiated in the background.    Run 'show mvx cluster enrollment status' nx-05 (config) # show mvx cluster enrollment status MVX Cluster Enrollment Status    Enrollment Client :        Status ok          : yes        Status description : enrolled        Last checked at    :2019/08/18 20:55:41 ... ```