--- title: "Update Sensor software in a HA pair" slug: "update-sensor-software-in-a-ha-pair" tags: ["Install and Get Started", "IPS 10.1.10"] updated: 2026-09-23T09:35:43Z published: 2026-09-23T09:35:43Z canonical: "docs.trellix.com/update-sensor-software-in-a-ha-pair" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Update Sensor software in a HA pair Because each Sensor in a HA pair must be rebooted after the software update, it is important to update the software in the correct order. ## Task 1. Push the software to each of the Sensors that are in the HA pair. You can follow one of these methods: - [Sensor Software and Signature Set Upgrade using Manager 6.0](/network-and-platform/docs/sensor-software-and-signature-set-upgrade-using-manager-10-1) - [Sensor software upgrade using a TFTP server](/network-and-platform/docs/sensor-software-upgrade-using-a-tftp-or-scp-server). 2. Load the image file on the **primary** Sensor. 3. Load the image file on the **secondary** Sensor. 4. Reboot the **primary** Sensor. After reboot, you need to verify the status of Sensor through CLI and confirm if it displays **SIGFILE** or **NO_SIGFILE**. If the Sensor displays **NO_SIGFILE**, manually deploy sigfile to the Sensor using Manager. 5. Now, reboot the **secondary** Sensor. After reboot, you need to verify the status of Sensor through CLI and confirm if it displays **SIGFILE** or **NO_SIGFILE**. If the Sensor displays **NO_SIGFILE**, manually deploy sigfile to the Sensor using Manager. Use the Performance Charts to verify the performance of the Sensors. This is to make sure the upgrade was successful. For information on how to check Sensor performance from **Performance Charts**, see Trellix Intrusion Prevention System Product Guide.