--- title: "Updating IPMI and BIOS firmware" slug: "updating-ipmi-and-bios-firmware-4" tags: ["Product Usage", "CMS 11.x", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "IVX 11.x", "Network Security"] updated: 2026-08-24T20:40:08Z published: 2026-08-24T20:40:08Z canonical: "docs.trellix.com/updating-ipmi-and-bios-firmware-4" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Updating IPMI and BIOS firmware This procedure describes how to use CLI commands to update IPMI and BIOS firmware on the Intelligent Virtual Execution - Server appliance. > [!NOTE] > Note > > The VX 5500 model requires an update to IPMI 3.11 and BIOS 1.9. You must update the IPMI before you update the BIOS. ### Updating IPMI firmware To update the IPMI firmware: > [!WARNING] > Caution > > IPMI network and password settings revert to factory defaults after this upgrade, and IPMI logs are deleted. Make a note of your settings and back up your IPMI logs. > [!WARNING] > Warning > > Do not shut down or remove power from the appliance during the update. 1. Go to CLI configuration mode. ``` hostname> enable hostname# configure terminal ``` 2. Check the version installed on the appliance: ``` hostname (config) # show ipmi ``` 3. Begin the update: ``` hostname (config)# ipmi firmware update latest ``` 4. Confirm the update: ``` hostname (config)# show ipmi ``` If the update fails, try the steps again. If IPMI functions are not fully restored, perform a full power cycle (cold shutdown) on the appliance: 1. Stop the reload process: ``` hostname (config)# reload halt ``` 2. Disconnect all power cables for two minutes. 3. After two minutes, reconnect power cables and restart the appliance. ### Updating BIOS firmware > [!WARNING] > Important > > Make sure the IPMI firmware is updated before you perform this procedure. **To update the BIOS firmware:** 1. Go to CLI configuration mode. ``` hostname> enable ``` ``` hostname# configure terminal ``` 2. Check the installed version: ``` hostname (config) # show system bios ``` 3. Begin the update: ``` hostname (config)# system bios firmware update latest ``` > [!WARNING] > Caution > > Do not shut down or remove power from the appliance during the update. 4. Confirm the update: ``` hostname (config)# show system bios ``` 5. Stop the reload process: ``` hostname (config)# reload halt ``` 6. Disconnect all power cables for two minutes. 7. After two minutes, reconnect power cables and restart the appliance.