--- title: "Using NAT (Network Address Translation)" slug: "using-nat-network-address-translation-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:28:23Z published: 2026-11-19T12:28:23Z canonical: "docs.trellix.com/using-nat-network-address-translation-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Using NAT (Network Address Translation) Network Address Translation (NAT) is a technique in which the source and/or destination addresses of IP packets are rewritten as they pass through a router or firewall. It is commonly used to enable multiple hosts on a private network to access the Internet using a single public IP address. Only static NAT entries are supported in Manager. Consider the following scenarios to explain the use of NAT in Manager: ### Scenario 1: Manager using a private IP address To establish the Manager-Sensor communication, configure the Manager's public IP address (external reachable) on the Sensor by using the following CLI command: ``` set manager IP ``` > [!NOTE] > Note > > To support multiple NIC cards, you need to select the respective local IP address in **Sensor Communication Interface** during Manager installation. > [!NOTE] > Note > > For more information on **Sensor Communication Interface**, see Trellix Intrusion Prevention System Installation Guide. ### Scenario 2: Sensor using a private IP address The Manager-Sensor communication works as usual. You need not make any changes to the setup to achieve this.