The table below summarizes all possible settings of speed and duplex for Sensors and Cisco catalyst switch ports.
| Trellix IPS Configuration 10/100/1000 port (Speed/Duplex) | Configuration of Switch
(Speed/Duplex) |
Resulting Sensor
(Speed/Duplex) |
Resulting Catalyst
(Speed/Duplex) |
Comments |
|---|---|---|---|---|
| 100 Mbps
Full-duplex |
1000 Mbps
Full-duplex |
No Link | No Link | Neither side establishes link due to speed mismatch |
| 100 Mbps
Full-duplex |
AUTO | 100 Mbps
Full-duplex |
100 Mbps
Full-duplex |
Correct configuration |
| 100 Mbps
Full-duplex |
1000 Mbps
Full-duplex |
100 Mbps
Full-duplex |
100 Mbps
Full-duplex |
Correct Manual Configuration |
| 100 Mbps
Half-duplex |
AUTO | 100 Mbps
Half-duplex |
100 Mbps
Half-duplex |
Link is established, but switch does not see any auto-negotiation information from Trellix Intrusion Prevention System and defaults to half-duplex when operating at 10/100 Mbps. |
| 10 Mbps
Half-duplex |
AUTO | 100 Mbps
Half-duplex |
100 Mbps
Half-duplex |
Link is established, but switch does not see Fast Link Pulse (FLP) and defaults to 10 Mbps half-duplex. |
| 10 Mbps
Half-duplex |
1000 Mbps
Half-duplex |
No Link | No Link | Neither side establishes link due to speed mismatch. |