The table below summarizes all possible settings of speed and duplex for Sensors and Cisco catalyst switch ports.
Trellix IPS Configuration 10/100/1000 port (Speed/Duplex) | Configuration of Switch (Speed/Duplex) | Resulting Sensor (Speed/Duplex) | Resulting Catalyst (Speed/Duplex) | Comments |
|---|---|---|---|---|
100 Mbps Full-duplex | 1000 Mbps Full-duplex | No Link | No Link | Neither side establishes link due to speed mismatch |
100 Mbps Full-duplex | AUTO | 100 Mbps Full-duplex | 100 Mbps Full-duplex | Correct configuration |
100 Mbps Full-duplex | 1000 Mbps Full-duplex | 100 Mbps Full-duplex | 100 Mbps Full-duplex | Correct Manual Configuration |
100 Mbps Half-duplex | AUTO | 100 Mbps Half-duplex | 100 Mbps Half-duplex | Link is established, but switch does not see any auto-negotiation information from Trellix Intrusion Prevention System and defaults to half-duplex when operating at 10/100 Mbps. |
10 Mbps Half-duplex | AUTO | 100 Mbps Half-duplex | 100 Mbps Half-duplex | Link is established, but switch does not see Fast Link Pulse (FLP) and defaults to 10 Mbps half-duplex. |
10 Mbps Half-duplex | 1000 Mbps Half-duplex | No Link | No Link | Neither side establishes link due to speed mismatch. |