--- title: "Valid auto-negotiation and speed configurations" slug: "valid-auto-negotiation-and-speed-configurations" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-09-06T12:33:59Z published: 2026-10-05T15:41:20Z canonical: "docs.trellix.com/valid-auto-negotiation-and-speed-configurations" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Valid auto-negotiation and speed configurations The table below summarizes all possible settings of speed and duplex for Sensors and Cisco catalyst switch ports. | Trellix IPS Configuration 10/100/1000 port (Speed/Duplex) | Configuration of Switch (Speed/Duplex) | Resulting Sensor (Speed/Duplex) | Resulting Catalyst (Speed/Duplex) | Comments | | --- | --- | --- | --- | --- | | 100 Mbps Full-duplex | 1000 Mbps Full-duplex | No Link | No Link | Neither side establishes link due to speed mismatch | | 100 Mbps Full-duplex | AUTO | 100 Mbps Full-duplex | 100 Mbps Full-duplex | Correct configuration | | 100 Mbps Full-duplex | 1000 Mbps Full-duplex | 100 Mbps Full-duplex | 100 Mbps Full-duplex | Correct Manual Configuration | | 100 Mbps Half-duplex | AUTO | 100 Mbps Half-duplex | 100 Mbps Half-duplex | Link is established, but switch does not see any auto-negotiation information from Trellix Intrusion Prevention System and defaults to half-duplex when operating at 10/100 Mbps. | | 10 Mbps Half-duplex | AUTO | 100 Mbps Half-duplex | 100 Mbps Half-duplex | Link is established, but switch does not see Fast Link Pulse (FLP) and defaults to 10 Mbps half-duplex. | | 10 Mbps Half-duplex | 1000 Mbps Half-duplex | No Link | No Link | Neither side establishes link due to speed mismatch. |