--- title: "Verification to check whether HA pair creation is successful" slug: "verification-to-check-whether-ha-pair-creation-is-successful" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-09-06T12:28:55Z published: 2026-10-05T15:41:20Z canonical: "docs.trellix.com/verification-to-check-whether-ha-pair-creation-is-successful" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Verification to check whether HA pair creation is successful If you have configured a HA pair before connecting the heartbeat cables, you will notice Failover peer status errors appearing on the **System Faults** monitor until you connect the heartbeat cable. These messages will not appear if the two communicate properly. Errors also appear when the **Media Type** is not selected as **Copper** when using copper SFPs. The status of the communication between the standalone Sensors can be monitored on the **Devices** → **** → **Devices** → **** → **Member Sensors** → **** → **Summary** page of the Manager interface or directly from the CLI of either Sensor. The status of the communication between the Sensors in a stack can be monitored on the **Devices** → **** → **Devices** → **** → **Member Sensors** → **** → **Summary** page of the Manager interface or directly from the CLI of either Sensor. The Sensor command line interface (CLI) is a valuable tool for verifying correct configuration as well as diagnosing possible problems. > [!NOTE] > Note > > For more information, see the CLI commands section.