--- title: "Verify your installation" slug: "verify-your-installation-3" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/verify-your-installation-3" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Verify your installation Follow these steps to make sure that your setup is working as designed. 1. Check the icons in the Manager beside the ports you have configured as in-line fail-open passive. They must show **Up**. 2. Check the power LED on the fail-open switch. | LED status | Description | | --- | --- | | ON | The switch is not in fail-open mode and the Sensor monitoring ports are operating normally. | | OFF | The switch is in fail-open mode and the Sensor monitoring ports are not monitoring traffic. | 3. Check the port status and operating mode status of the Gigabit inline fail-open mode. | In-line Fail-Open Port Status | Port color on the Sensor | Operating Mode Status | | --- | --- | --- | | In-line Fail-Open - Passive (Paired with a/b) | Green | The in-line fail-open device is in in-line fail-open mode. | | Bypassing | Yellow | The in-line fail-open device is in in-line bypass mode. The bypass switch has been activated. The Sensor does not monitor during this time. | | Switch Absent | Red | Fail-open control is not present, control cable is not present, or bypass switch is not present. Verify that all three components are connected properly. If everything is connected correctly, check the Operational Status. | | N/A | Gray | Not Applicable; the operating mode is not in in-line fail-open mode. |