--- title: "Viewing resource agent status using the CLI" slug: "viewing-resource-agent-status-using-the-cli" tags: ["Central Management System", "Install and Get Started"] updated: 2026-10-01T07:37:46Z published: 2026-10-01T07:37:46Z canonical: "docs.trellix.com/viewing-resource-agent-status-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Viewing resource agent status using the CLI Use the commands in this section to view the current status of resource agents on both nodes. To view resource agent status: 1. Log in to either node. 2. Enable the CLI enable mode: ```plaintext node-hostname > enable ``` 3. View the resource agent status: ```plaintext node-hostname # show ha resources ``` For a description of the resource agent states, see [Viewing resource agent status](/network-and-platform/docs/viewing-resource-agent-status-1) . ### Example The following example shows the resource agent status from the primary node. ```plaintext node1 # show ha resources Resource Status                                node1      node2  Resources  Resources 15         sys_disk_monitor:      running    running         sys_ether1_monitor:    running    running         fe_address:            off        off         fe_correlator:         running    off         fe_cmsapi:             running    off         fe_dbmgd:              running    off  fe_vsmon:              running    off         fe_aggregator:         running    off         fe_aggr:               running    off         fe_fedb:               running    running         fe_webui:              running    off         fe_redis:              running    off         fe_peer_service:       running    off         fe_notification:       running    off         fe_http:               running    running         fe_appmgrd:            running    off ``` :