--- title: "Viewing the Cluster Configuration Using the CLI" slug: "viewing-the-cluster-configuration-using-the-cli" tags: ["Central Management System", "Install and Get Started"] updated: 2026-08-21T19:17:36Z published: 2026-08-21T19:17:36Z canonical: "docs.trellix.com/viewing-the-cluster-configuration-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Viewing the Cluster Configuration Using the CLI Use the commands in this section to view the cluster configuration. To view the cluster configuration: 1. Log in to either node. 2. Enable the CLI enable mode: ``` node-hostname > enable ``` 3. View the status: ``` node-hostname # show ha configuration ``` ### Examples The following example displays the cluster configuration on node1 in the default single-interface configuration. In this configuration, ether1 is the default HA interface, and there is no backup HA interface, VIP address, or IP routing. ``` node1 # show ha configuration CM HA Cluster Settings:   Authkey md5sum:                 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX   Virtual IP address:             0.0.0.0   Auto-failover:                  yes   Split-brain auto-shutdown:      no   Replicating:       Configuration:              yes       Alerts:                     yes       Security content:           yes Cluster Communications:  Default Interface:      ether1     Enabled:             yes     Members:             10.0.1.1/node1, 10.0.1.2/node2  Backup Interface:       ether3     Enabled:             no     Members:             0.0.0.0/node1, 0.0.0.0/node2  Cluster Resources:         sys_disk_monitor enabled:    yes     sys_ether1_monitor enabled:  yes     fe_address enabled:          no     fe_correlator enabled:       yes     fe_cmsapi enabled:           yes     fe_dbmgd enabled:            yes     fe_vsmon enabled:            yes     fe_aggregator enabled:       yes     fe_aggr enabled:             yes     fe_fedb enabled:             yes     fe_webui enabled:            yes     fe_redis enabled:            yes     fe_peer_service enabled:     yes     fe_notification enabled:     yes     fe_http enabled:             yes     fe_appmgrd enabled:          yes   ``` The following example displays the cluster configuration on node1 in the dual-interface LAN configuration. ``` node1 # show ha configuration CM HA Cluster Settings:   Authkey md5sum:               XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX   Virtual IP address:           0.0.0.0   Auto-failover:                yes   Split-brain auto-shutdown:    no   Replicating:       Configuration:            yes       Alerts:                   yes       Security content:         yes Cluster Communications:  Default Interface:      ether3     Enabled:             yes     Members:             10.0.0.1/node1, 10.0.0.2/node2,  Backup Interface:       ether3     Enabled:             yes     Members:             10.0.1.1/node1, 10.0.1.2/node2,  Cluster Resources:         sys_disk_monitor enabled:    yes     sys_ether1_monitor enabled:  yes     fe_address enabled:          no     fe_correlator enabled:       yes     ... ``` :