--- title: "Viewing the data exfiltration whitelist using the CLI" slug: "viewing-the-data-exfiltration-whitelist-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-10-01T12:02:00Z published: 2026-10-01T12:02:00Z canonical: "docs.trellix.com/viewing-the-data-exfiltration-whitelist-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Viewing the data exfiltration whitelist using the CLI Use the `show smartvision config` command to view the data exfiltration alerts whitelist. This whitelist specifies *destination IPv4 addresses* only. The appliance does not generate data exfiltration alerts for data uploads to hosts or networks in the data exfiltration whitelist. For detailed information about the command, see [show smartvision config](/network-and-platform/docs/show-smartvision-config). ### Note SmartVision maintains two whitelists. The **SmartVision** **alerts whitelist** applies to all post-exploitation attacker events, including data exfiltration events. The **data exfiltration detection whitelist** applies to data exfiltration events only. ### Prerequisites - Admin access to the SmartVision appliance. To view the data exfiltration detection whitelist: 1. Log in to the appliance CLI and go to enable mode: ```plaintext hostname > enable ``` 2. To view the data exfiltration detection whitelist, use the `show smartvision config` command. The following example shows a single IPv4 address range in the data exfiltration detection whitelist: ```plaintext hostname # show smartvision config SmartVision Config              .              .              .        Data exfil detection whitelist network:                 192.168.0.0/24              .              .              . ``` :