--- title: "Viewing the SmartVision alerts whitelist using the CLI" slug: "viewing-the-smartvision-alerts-whitelist-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-02T17:27:05Z published: 2026-09-02T17:27:05Z canonical: "docs.trellix.com/viewing-the-smartvision-alerts-whitelist-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Viewing the SmartVision alerts whitelist using the CLI Use the `show smartvision alert whitelist` command to view the SmartVision alerts whitelist. Each entry in the list specifies a combination of conditions. If a SmartVision event matches all conditions specified by any entry in the whitelist, the appliance does not generate an alert for that event. Each whiteslist entry specifies one or more of the following conditions: **Rule** A single SmartVision rule ID. **Source Prefix** A single IPv4 or IPv6 source address, specified in classless inter-domain routing CIDR format (`<ipAddress>/<prefix>`). **Dest Prefix** A single IPv4 or IPv6 destination address specified in CIDR format. ### Prerequisites - Admin access to the SmartVision appliance. To view the alerts whitelist: 1. Log in to the appliance CLI and go to enable mode: ``` hostname > enable ``` 2. View the SmartVision configuration. ``` hostname # show smartvision alert whitelist SmartVision Alert Whitelist Config Rule        Source Prefix         Dest Prefix           Type 851234      192.168.4.0/24        172.168.4.0/24        rule-source-dest 91500079    192.168.4.0/24        -                     rule-source 91500079    192.168.4.0/2         192.168.255.0/24      rule-source-dest ``` :